Termination with ProCaP
For BNC and other coaxial connectors
1
INSTALLATION
After the cable preparation (see instructions here) , insert the centre conductor into the F female connector and fold the braid and the jacket over the thread by sliding the CaP over it. Lay the coaxial cable through the flat side of the professional pliers (ProCaP). Slip the connector groove in the fingers on the far side. Gently squeeze the pliers to secure the connector. Unlike compression connectors, CaP does not require force.
2
REMOVAL
With the ProCaP fully open, insert the connector groove in the middle fingers and squeeze the handles to open the connection.
Termination with PiCaP
For BNC and other coaxial connectors
1
INSTALLATION
After the cable preparation (see instructions here) , insert the centre conductor into the F female connector and fold the braid and jacket over the thread by sliding the CaP over it. Insert the connector between the handle tips of the economic pliers (PiCaP). To terminate the connection squeeze the handles, placing your hand near the connector to obtain greater leverage.
2
REMOVAL
Insert the connector groove in the fingers (closed) at the top of the PiCaP and squeeze the handles to open the connection.
Termination with Pu-PuCaP
For an easier installation of the CaP onto large devices, in restricted spaces or when F female connectors are placed very close together, we developed a specific inserter/extractor tool (Pu-PuCaP).
1
INSTALLATION
After preparing the cable (see instructions here), place the CaP in the groove on the end of the PuPuCaP and insert the cable centre into the F female connector. Slide the CaP towards the F female, thus causing the braid and cable sheath to fold over the thread. Terminate the connection by simultaneously pushing and swinging the Pu-PuCaP until the CaP is fully inserted on the F female connector.
2
REMOVAL
Hook the PuPuCaP into the CaP. Simultaneously pull and swing the Pu-PuCaP, levering on the female F, until the CaP and cable are completely detached from the device.